Select And Start A Washing Programme - Electrolux ESF66820 Benutzerinformation

90 electrolux
Rinse aid dispenser activated
4. To change the setting, press button B
again, the digital display indicates the
new setting.
5. To memorize the operation, switch off the
dishwasher by pressing the On/Off but-
ton.
If you decide to revert back to the
use of individual detergents we ad-
vise that you:

Select and start a washing programme

Select the washing programme and
delay start with the door slightly
opened. The start of the programme
or the countdown of the delay start
will occur only after the closure of
the door. Until then it is possible to
modify the settings
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the On/Off button. The dishwasher
must be in setting mode.
4. Press the button corresponding to the re-
quired programme (see ''Washing pro-
grammes'' chart).
When a programme has been selected
the corresponding light comes on.
The programme in progress indicator
light comes on.
Close the dishwasher door, the pro-
gramme starts automatically.
The programme in progress indicator
light remains on.
Setting and starting the programme with
delay start
1. Once selected the washing programme,
press the delay start button until the flash-
ing number of hours for the delay start
appear in the digital display. The start of
the selected washing programme can be
delayed for between 1 and 19 hours.
2. Close the dishwasher door, the count-
down starts automatically. The number in
the display is no longer flashing but fixed
with static light.
With the delay start function set, the
programme in progress indicator light
1. Deactivate the Multitab function.
2. Fill up the salt container and the rinse
aid dispenser again.
3. Adjust the water hardness setting to
the highest setting and perform 1
normal washing programme without
loading any dishes.
4. Adjust the water hardness setting
according to the hardness of the wa-
ter in your area.
5. Adjust the rinse aid dosage.
goes off. Once the countdown of the de-
lay start has elapsed, the washing pro-
gramme will start automatically and the
programme in progress indicator light
comes on.
3. The countdown will decrease with steps
of 1 hour.
4. The opening of the door will interrupt the
countdown. Close the door; the count-
down will continue from the point at
which it was interrupted.
5. Once the delay start has elapsed the pro-
gramme will start automatically.
The selection of the washing pro-
gramme and delay start can occur also
with the door closed.
When you press a programme button
you have ONLY 3 seconds to select a
different programme or a delay start.
After these 3 seconds, the selected pro-
gramme starts automatically.
Warning! Interrupt or cancel a
washing programme in progress
ONLY if it's absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
Interrupt a washing programme in
progress
• Open the dishwasher door; the pro-
gramme will stop. Close the door; the pro-
gramme will start from the point at which
it was interrupted.
• Press the On/Off, all indicator lights will go
off. Press the On/Off button again; the pro-
gramme will start from the point at which
it was interrupted.