Use Of Dishwasher Salt - Electrolux GS55GLI201 Benutzerinformation

Water hardness
°dH
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
Setting electronically
The dishwasher is factory set at level 5.
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Simultaneously press and hold function
buttons B and C , until the lights of func-
tion buttons A , B and C start flashing.
3. Press function button A , the lights of
function buttons B and C go off while the
light of function button A continues to
flash. The current level shows on the dig-
ital display and a sequence of intermittent
audible signals are heard.
Examples:
displayed, 5 intermittent audible sig-
nals, pause,
audible signals, pause, etc... = level 5

Use of dishwasher salt

Warning!
Only use salt specifically designed for use in
dishwashers. All other types of salt not spe-
cifically designed for use in a dishwasher, es-
pecially table salt, will damage the water soft-
ener. Only fill with salt just before starting one
of the complete washing programmes. This
will prevent any grains of salt or salty water,
which may have been spilt, remaining on the
bottom of the machine for any period of time,
which may cause corrosion.
To fill:
1. Open the door, remove the lower basket
and unscrew the cap of the salt container
by turning it anticlockwise.
2. Pour 1 litre of water into the container
(this is necessary only before filling
with salt for the first time) .
3. Pour in the salt until the container is full.
°TH
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
< 7
displayed, 5 intermittent
Adjusting the water
hardness setting
mmol/l
4,0 - 5,0
3,3 - 3,9
2,6 - 3,2
1,9 - 2,5
0,7 - 1,8
< 0,7
displayed, 10 intermittent audible
signals, pause,
mittent audible signals, pause, etc... =
level 10
4. To change the level, press function but-
ton A . Each time the button is pressed
the level changes. (For the selection of the
new level see the chart)..
Examples: If the current level is 5, by
pressing function button A once, level 6
is selected. if the current level is 10, by
pressing function button A once, level 1
is selected.
5. To memorize the operation, switch off the
dishwasher by pressing the On/Off but-
ton.
4. Replace the cap making sure that there
is no trace of salt on the screw thread or
on the gasket.
5. Replace the cap tightly turning it clock-
wise until it stops with a click.
Do not worry if water overflows from the
unit when filling with salt, this is quite
normal.
electrolux 85
Use of
level 6
level 5
level 4
level 3
level 2
level 1
displayed, 10 inter-
salt
yes
yes
yes
yes
yes
no