Electrolux GS55GLI201 Benutzerinformation Seite 101

thread spout or to a purpose made quick-
coupling tap such as the Press-block.
The water pressure must be within the limits
given in the "Technical data". Your local Wa-
ter Authority will advise you on the average
mains pressure in your area.
The water inlet hose must not be kinked,
crushed, or entangled when it is being con-
nected.
The dishwasher features water inlet and drain
hoses which can be turned either to the left
or the right to suit the installation by means
of the locknut. The locknut must be cor-
rectly fitted to avoid water leaks.
Attention! NOT all models of dishwash-
ers have water inlet and drain hoses pro-
vided with a locknut. In this case, this fa-
cility is not available.
If the machine is connected to new pipes or
pipes which have not been used for a long
time, you should run the water for a few mi-
nutes before connecting the water inlet hose.
DO NOT use connection hoses which
have previously been used on an old ap-
pliance.
This appliance has been fitted with safe-
ty features which will prevent the water
used in the appliance from returning
back into the drinking water system. This
appliance complies with the applicable
plumbing regulations.
Installation of an IRG filter is recommen-
ded on the construction side.
Water inlet hose with safety valve
After connecting the double-walled water in-
let hose, the safety valve is next to the tap.
Therefore the water inlet hose is only under
pressure while the water is running. If the wa-
ter inlet hose starts to leak during this oper-
ation, the safety valve cuts off the running
water.
Please take care when installing the water
inlet hose:
• The electrical cable for the safety valve is
in the double-walled water inlet hose. Do
not immerse the water inlet hose or the
safety valve in water.
• If water inlet hose or the safety valve is
damaged, remove the mains plug imme-
diately.
• A water inlet hose with safety valve must
only be replaced by the Service Force
Centre.
Warning! Dangerous voltage
Water drain connection
The water drain hose can face either to the
right or left of the dishwasher
Ensure that the hose is not bent or squashed
as this could prevent or slow down the dis-
charge of water.
The sink plug must not be in place when the
machine is draining as this could cause the
water to syphon back into the machine.
The drain connection must be at a maximum
height of 70 cm from the ground.
D
C
G 546
N 550
B
A = drain outlet
G = size of the appliance
K = cold water supply
N = size of the recess
W = hot water supply
E = socket
When connecting the water drain hose to an
under sink trap spigot, the entire plastic
electrolux 101
D
W K E
A
70
C
100 180 50
550
B