Technical Data; Installation - Electrolux GS55GLI201 Benutzerinformation

Mod. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The dishes are not
clean
The dishes are wet
and dull
There are streaks,
milky spots or a blu-
ish coating on
glasses and dishes
Water drops have
dried onto glasses
and dishes
If after all these checks, the problem persists,
contact your local Service Force Centre.

Technical data

Dimensions
Electrical connection - Voltage -
Overall power - Fuse
Water supply pressure
Capacity

Installation

Warning! Any electrical and/or
plumbing work required to install
this appliance should be carried out
by a qualified electrician and/or
plumber or competent person.
Remove all packaging before positioning the
machine.
If possible, position the machine next to a
water tap and a drain.
This dishwasher is designed to be fitted un-
der a kitchen counter or work surface.
The wash results are not satisfactory
• The wrong programme has been selected.
• The dishes are arranged in such a way as to stop water reaching all parts
of a surface. The baskets must not be overloaded.
• The spray arms do not rotate freely due to incorrect arrangement of the
load.
• The filters in the base of the washing compartment are dirty or incorrectly
positioned.
• Too little or no detergent has been used.
• Where there are limescales deposits on the dishes; the salt container is
empty or incorrect level of the water softener has been set.
• The drain hose connection is not correct.
• The salt container cap is not properly closed.
• Rinse aid was not used.
• The rinse aid dispenser is empty.
• Decrease rinse aid dosage.
• Increase rinse aid dosage.
• The detergent may be the cause. Contact the detergent manufacturer con-
sumer care line.
Width
Height
Depth
Information on the electrical connection is given on the rating plate
on the inner edge of the dishwasher door.
Minimum
Maximum
S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
To integrate the door with a panel see the
enclosed template.
No further openings for the venting of the
dishwasher are required, but only to let the
water inlet and drain hoses and mains cable
pass through.
During all operations that involve accessibility
to internal components the dishwasher has
to be unplugged.
When inserting the machine, ensure that the
water inlet hose, the water drain hose and the
mains cable are not kinked or squashed.
electrolux 99
54,6 cm
75,9 cm
56,3 cm
0,05 MPa (0,5 bar)
0,8 MPa (8 bar)
11 place settings