First Use; Setting The Water Softener - Electrolux GS55GLI201 Benutzerinformation

84 electrolux
formed or selected programme is still set. In
this case, to return to setting mode, the pro-
gramme has to be cancelled.
To cancel a set programme or a
programme in progress
Simultaneously press and hold the two func-
tion buttons B and C until the 2 horizontal
bars appear in the digital display. The pro-
gramme has been cancelled and the appli-
ance is now in setting mode.
Audible signals
Audible signals have been introduced to help
indicate which operations the dishwasher is
performing:
– setting of the water softener,
– end of the washing programme,
– intervention of an alarm due to malfunction
of the machine.
Factory setting: audible signals activated
It is possible to deactivate the audible
signals.

First use

Before using your dishwasher for the first
time:
• Ensure that the electrical and water con-
nections comply with the installation in-
structions
• Remove all packaging from inside the ap-
pliance
• Set the water softener level

Setting the water softener

The dishwasher is equipped with a water
softener designed to remove minerals and
salts from the water supply, which would
have a detrimental or adverse effect on the
operation of the appliance.
The higher the content of these minerals and
salts, the harder your water is. Water hard-
ness is measured in equivalent scales, Ger-
man degrees (dH°), French degrees (°TH)
Water hardness
°dH
51 - 70
43 - 50
37 - 42
29 - 36
°TH mmol/l
91 - 125 9,1 - 12,5
76 - 90 7,6 - 9,0
65 - 75 6,5 - 7,5
51 - 64 5,1 - 6,4
Deactivation/activation of the audible
signals
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Simultaneously press and hold the func-
tion buttons B and C until the lights of
function buttons A , B and C start flash-
ing.
3. Press function button C , the lights of
function buttons A and B go off while the
light of function button C goes on flash-
ing. The digital display shows the current
level.
Audible signals deactivated
Audible signals activated
4. To change the setting, press function
button C again; the digital display will
show the new setting.
5. 5. To memorize the operation, switch off
the dishwasher by pressing the On/Off
button.
• Pour 1 litre of water into the salt container
and then fill with dishwasher salt
• Fill the rinse aid dispenser
If you want to use combi detergent
tablets such as: '3 in 1', '4 in 1', '5 in
1' etc. set the multitab function. (Re-
fer to 'Multitab function').
and mmol/l (millimol per litre - international
unit for the hardness of water).
The softener should be adjusted according
to the hardness of the water in your area.
Your local Water Authority can advise you on
the hardness of the water in your area.
Adjusting the water
hardness setting
level 10
level 9
level 8
level 7
Use of
salt
yes
yes
yes
yes