Starting The Cutting; Fast Down; Setting The Feed Rate During Cutting - struers Unitom-5 Bedienungsanleitung

Starting the Cutting

Fast down

Setting the Feed Rate during
Cutting
16
Unitom-5
Instruction Manual
Before starting, lower the cut-off wheel into correct position
above the workpiece.
Carefully close the protecting guard.
s
Press START
cooling water starts running. The cut-off wheel moves down
with the pre-set feed rate.
You may increase the feed rate to twice the pre-set value between
pressing start and the cut-off wheel physically touching the
workpiece.
Press the function key F1. The cut-off wheel moves down fast
until it touches the workpiece. From that minute, Unitom-5
automatically changes the feed rate back to the pre set value.
D
e
Press ENTER
Two square brackets [ ] appear around the value.
D
mO
Press MENU UP/DOWN
mN to increase or decrease the numeric value.
D
e
Press ENTER
Pressing Esc, aborts the changes, preserving the
original value.
. The cut-off wheel starts rotating and the
e
, to edit the value.
mON
e
, to accept the new value.