Maintenance; Daily Service; Checking The Recirculation Unit; Weekly Service - struers Unitom-5 Bedienungsanleitung

Daily Service

Checking the Recirculation Unit

Weekly Service

Unitom-5
Instruction Manual

5. Maintenance

Service and greasing of the cutting table and quick-clamping
devices is part of a regular Struers Service Schedule.
Please contact your Struers Representative for details.
Clean the cutting chamber, especially the cutting table with
the T-slots.
Clean the protection guard window with a damp cloth. Do not
use the cleaning hose.
Do not clean the lamp glass with alcohol.
Empty and clean the sieve in the Recirculation Cooling Unit.
The cooling unit should be checked for cooling water after 8 hours
use or at least every week. Refill the cooling unit if the flushing
pump cannot reach the cooling water.
Remember to add Struers Additive for Cooling Fluid: One part of
Additive for 33 parts of water.
Use a refractometer to check the concentration of additive.
Concentration = Brix value.
The concentration of additive should lie between 2.7 and 3.3 %.
Add Struers Additive for Cooling Fluid if the concentration is too
low.
Always maintain the correct concentration of Struers Additive in the cooling
water (percentage stated on the container of the Additive). Remember to
add Struers Additive for cooling fluid each time you refill with water.
Clean the cutting chamber thoroughly.
Remove the pump and clean the sieve.
Clean and lubricate the safety lock.
IMPORTANT
Use a damp cloth.
IMPORTANT
35