Starting The Cutting; Fast Down; Setting The Feed Rate During Cutting - struers Unitom-50 Benutzerhandbuch

Starting the Cutting

Fast down

Setting the Feed Rate during
Cutting
16
Unitom-50
Instruction Manual
Before starting, lower the cut-off wheel into the correct position
above the workpiece.
Close the protecting guard.
s
Press START . The cut-off wheel starts rotating and the
cooling water starts running. The cut-off wheel moves down at
the pre-set feed rate.
You may increase the feed rate to twice the pre-set value between
pressing start and the cut-off wheel physically touching the
workpiece.
Press the function key F1. The cut-off wheel quickly moves
down until it touches the workpiece. Unitom-50 will then
automatically change the feed rate back to the pre set value.
e
Press ENTER
Two square brackets [ ] appear around the value.
D
mO
Press MENU UP/DOWN
mN the numeric value.
D
e
Press ENTER
Pressing Esc, aborts the changes, preserving the
original value.
e
, to edit the value.
mON
to increase or decrease
e
, to accept the new value.