Using The Remote Control; Using The Shutter Function; Using The Freeze Function; Switching The Input Signal - Christie LX1750 Bedienungsanleitung

Using the remote control

Using the shutter function

You can fully block the projection light.
button
1) Press the <SHUTTER> button on the
remote control.
z
z This blocks the projection light. The shutter
indicator <SHUTTER> lights up in blue.
2) Press the <SHUTTER> button again.
z
z This opens the shutter and restarts projection.
The shutter indicator <SHUTTER> goes off.
Note
z The operations of the shutter differ depending on
the settings. Perform the settings using [Shutter] in
the [Setting] menu.
z The <SHUTTER> button is also on the control
panel.
z If an error message appears when you press the
<SHUTTER> button, the button lock is enabled.
Check the [Shutter] setting from the [Setting] menu.
LX1750 User Manual
020-000638-01 Rev.1 (11-2013)
Using the remote control

Using the freeze function

You can temporarily freeze the projected image
regardless of the state of playback in an external
device.
button
1) Press the <FREEZE> button on the
remote control.
z
z This freezes the image.
2) Press the button on the remote control
or the control panel.
z
z Releases the frozen image.

Switching the input signal

You can switch the input signal for projection.
buttons
1) Press the <INPUT 1> - <INPUT 4>
buttons on the remote control.
z
z Each press of the button changes the input
signal.
z
z The <INPUT 3> button and the <INPUT 4>
button are only enabled when an input module
is inserted.
<INPUT 1> button
[RGB(PC analog)]
[RGB(Scart)]
[RGB(PC digital)]
[RGB(AV HDCP)]
[HDMI]
<INPUT 2> button
[RGB]
[Y,Pb/Cb,Pr/Cr]
[Video]
[S-video]
ENGLISH - 37