Remote Control Battery Installation - Christie LX505 Kurzanleitung

Remote Control Battery Installation

1
Open the battery
compartment lid.
Press the lid
downward
and slide it.
To ensure safe operation, please observe the following precautions :
● Use two (2) AAA or LR03 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean and install new
batteries.
● Risk of an explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.
Remote Control
③ ②
④
⑤
⑥
⑦
⑧
⑨
⑭
① STAND-BY button
Turn the projector off.
② WIRED REMOTE jack
Connect the remote control cable (not
supplied) to this jack when using as a wired
remote control.
Note:
To ensure safe operation, please observe the
following precautions:
– Do not bend, drop, or expose the remote
control to moisture or heat.
– For cleaning, use a soft dry cloth. Do not
apply benzene, thinner, spray, or any chemical
material.
Setup Guide
020-000540-01 Rev. 1 (11-2010)
2
Install new batteries into
the compartment.
①
⑬
⑫
⑪
⑩
11
Two AAA size batteries
For correct polarity (+ and
–), be sure battery terminals
are in contact with pins in
compartment.
③ SIGNAL EMISSION indicator
Light red while a signal is being sent from
the remote control to the projector.
④ ON button
Turn the projector on.
⑤ AUTO PC button
Automatically adjust the computer image to
its optimum setting.
⑥ INPUT button
Select a signal.
⑦ MENU button
Open or close the On-Screen Menu.
⑧ SCREEN button
Select the screen size.
⑨ POINT ▲▼◄►( VOLUME – / +, MUTE)
buttons
– Select an item or adjust the value in the
On-Screen Menu.
– Pan the image in Digital zoom + mode.
– Adjust the volume level (with Point ◄►
buttons) or mute the sound (with Point ▼
button.).
⑩ MOUSE POINTER button
Move a pointer of the projector or a pointer
for wireless mouse operation.
⑪ SELECT button
– Execute the selected item.
– Zoom in and out the image in the Digital
zoom mode.
⑫ SHUTTER button
Close and open up the built-in shutter.
⑬ INFO. button
Display the input source information.
⑭ L-CLICK button
Act as the left mouse button for wireless
mouse operation.
3
Replace the
compartment lid.
LX505/605