Christie LX1750 Bedienungsanleitung Seite 79

About indicator status
■ When operating correctly z
The status of the indicator is displayed with the following symbols.
L: Off, G: On, #: Flashing, I: On or Flashing
<STAND-
<POWER>
BY>
Green
Red
L L
L G
G L
*2
L #
*2
# G
*2 *2
# #
G L
L G
*2
L #
*1: The indicator will change according to different conditions, regardless of the status of other indicators.
*2: The indicator will flash in approximately 1-second intervals.
78 - ENGLISH
Indicator
<WARNING <WARNING
<SHUTTER>
TEMP.> FILTER>
Blue
Red Orange
L L L
*1 *1 *1
L I I
*1 *1
L I L
*1 *1 *1
L I I
*1 *1
L I L
*1 *1
L I L
*1 *1
L I G
*1 *2
L I #
*1 *2
L I #
<LAMP Status of the projector
REPLACE>
Orange
The power plug has been removed from the outlet.
L
The projector is in the standby mode.
Turns on when pressing the power <ON> button on
*1
I
the remote control or the power <ON/STAND-BY>
button on the control panel.
The projector is operating normally.
*1
I
The lamp is cooling down.
The projector does not turn on when pressing the
power <ON> button on the remote control or the
*1
I
power <ON/STAND-BY> button on the control panel
until the standby indicator <STAND-BY> changes to
on.
The projector is in the power management mode.
The lamp will turn on when controlling the projector,
*1
I
allowing the user to start operating it.
Power management mode is ON and the lamp is
*1
I
cooling down.
The shutter function has been turned on.
Press any button on the remote control or the control
*1
I
panel to cancel the function.
The projector is in the shutter management mode.
The lamp will turn on when controlling the projector,
*1
I
allowing the user to start operating it.
Shutter management mode is on and the lamp is
*1
I
cooling down.
LX1750 User Manual
020-000638-01 Rev.1 (11-2013)