Satelec Implant Center 2 Bedienungsanleitung Seite 50

To access the T
OOLBOX
then press button
a) Audio volume adjustment
Adjust the audio volume value
volume is adjustable from 0% to 100%.
The relative value of the audio volume is displayed (Fig. 10-48).
b) Brightness adjustment
Adjust the brightness value
brightness is adjustable from 30% to 100%.
The brightness level setting is displayed (Fig. 10-49).
c) Light off time-out adjustment
Adjust the time-out length value
The length of the adjustable time-out (from nine seconds to 18 seconds) is displayed (Fig. 10-50).
d) Storing the settings
To store the modified settings, press button
e) Factory configuration reset
Press button
The factory configurations for the P
10-52) is pressed. The screen shown in Fig. 9 reappears.
f) Software version
The version of the software is displayed at the bottom of the screen (Fig. 10-51).
I C 2 is configured in the factory with the following settings:
MPLANT ENTER
I-S mode:
URGE
Contra-angle
Program
ratio
P1 20 :1
P2 20 :1
P3 20 :1
P4 20 :1
function, switch OFF the device, wait four seconds, switch the device ON again,
(Fig. 9-41) on the welcome screen (Fig. 9).
(Fig. 10-43) using buttons
(Fig. 10-44) using buttons
(Fig. 10-45) by pressing buttons
(Fig. 10-42) to restore the factory configuration settings.
IEZOTOME
Speed at
instrument
end
1200 rpm
800 rpm
15 rpm
30 rpm
and
(Fig. 10-52). The screen shown in Fig. 9 reappears.
and N functions are effective when button
EWTRON
Torque at
instrument Irrigation
end
80 N.cm 80 ml / min
80 N.cm 100ml / min
20 N.cm 100ml / min
20 N.cm
(Fig. 10-46 and 47). The audio
and (Fig. 10-46 and 47). The
and (Fig. 10-46 and 47).
Functions
Implant site
marking
Pilot drilling
Boring / tapping
0 Screwing
(Fig.