Satelec Implant Center 2 Bedienungsanleitung Seite 40

Identification of key areas that also display information (Fig. 6)
- 23: -Select micro-motor rotation (clockwise or counterclockwise).
- 24: Select program: P1, P2, P3, P4.
Contra-angle, speed and torque setting adjustment page
Identification of common information display areas (Fig. 7)
- 25: Contra-angle ratio.
- 26: Maximum delivered speed.
- 27: Maximum delivered torque.
Identification of common key areas (Fig. 7)
- 28: Exit from the page without changes.
- 29: Delete last character entered.
- 30: -Return to main page and save settings to screen memory.
- 31: Numeric keypad.
Preprogrammed contra-angle adjustment page
Identification of information display areas (Fig. 8)
- 38: Contra-angle ratio.
- 39: Motor speed value.
- 40: Motor delivered torque value.
Identification of key areas (Fig. 8)
- 32: Exit from the page without changes.
- 33: Select custom contra-angle.
- 34: -Return to main page and save settings to screen memory.
Identification of key areas that also display information (Fig. 8)
- 35: Select step-up contra-angle.
- 36: Select direct contra-angle.
- 37: Select step-down contra-angle.
Startup page:
Identification of key areas (Fig. 9)
- 41: Enter toolbox mode.
Toolbox:
Identification of information display areas (Fig. 10)
- 43: Audio volume symbol.
- 44: Screen brightness symbol.
- 45: Light off time-out symbol.
- 48: Relative audio volume value.
- 49: Relative brightness level value.
- 50: Selected time-out value.
- 51: Software version.
Identification of key areas (Fig. 10)
- 42: Reset factory configuration.
- 46: Reduce value.
- 47: Increase value.
- 52: Validate the configuration.