Satelec Implant Center 2 Bedienungsanleitung Seite 47

Confirm the selected contra-angle by pressing button
Programming a user-defined contra-angle:
I C 2 enables specific contra-angles to be used. A contra-angle value can be programmed.
MPLANT ENTER
On the main screen press button
(Fig.8).
Press button
Press button (Fig.8-34); the contra-angle adjustment screen is displayed (Fig.7).
Program the contra-angle using the numeric keypad (Fig. 7-31).
The programmed contra-angle value is displayed (Fig. 7-25).
Press button to delete the last digit.
Press button (Fig. 7-28) to return to the main screen without saving the changes.
Confirm your customization of the contra-angle by pressing button
displayed.
The maximum permitted speed (Fig. 6-18) and torque (Fig. 6-19) are displayed for the programmed
contra-angle.
d) Speed adjustment
On the main screen, press button
Program the speed using the numeric keypad (Fig. 7-31).
The programmed speed is displayed (Fig. 7-26).
Press button (Fig. 7-29) to delete the last digit.
Press button (Fig. 7-28) to return to the main screen without saving the changes.
Confirm the speed adjustment by pressing button
Note: The instrument speed can be adjusted directly using buttons
programs , or
To obtain a stable speed adjustment result, it is recommended to press the footswitch fully (Fig. 11-2).
Pressing buttons or
Pressing and holding buttons
or reduction of the speed value.
If a torque or speed value outside the permitted range is entered, !min! or !max! is displayed. The
maximum or minimum permitted value is then displayed, depending on the case.
e) Torque adjustment
On the main screen, press button
Program the torque using the numeric keypad (Fig. 7-31).
The programmed torque is displayed (Fig. 7-27).
Press button (Fig.7-29) to delete the last digit.
Press button (Fig. 7-28) to return to the main screen without saving the changes.
(Fig. 6-20); the preprogrammed contra-angle options are displayed
(Fig. 8-33); the button is highlighted.
(Fig. 6-21); the speed adjustment screen is displayed (Fig. 7).
even when the multifunction footswitch is switched on.
(Fig. 3-6 and 3-7) increases or reduces the speed value.
or (Fig. 3-6 and 3-7) for longer than 3 seconds causes faster increase
(Fig. 6-22); the torque adjustment screen is displayed (Fig. 7).
(Fig.8-34); the main screen is displayed.
(Fig.7-30); the main screen is
(Fig.7-30); the main screen is displayed.
or (Fig. 3-6 and 3-7) for