Installing The Condenser - Heidolph Laborota 4000 efficient Betriebsanleitung

Setup and initial use
4.5.3
WARNING
CAUTION
90

Installing the condenser

Screw coupling is removed from the drive head.
Tension spring is removed from drive head.
Vapour tube is installed in drive.
PTFE seal is installed on vapour tube.
Danger of glass breakage!
Risk of severe injury due to broken glass.
Check glass parts for damage (cracks, chips, etc.)
Use only glass parts that are in flawless condition.
Handle with care.
Drive rotating unintentionally!
Danger of injury to hands.
Ensure that the rotation is turned off.
Fig. 4-8: Installing glassware (here: glassware G1)
1. Version glassware sets G1 and G3:
– Slide screw coupling (2) over the condenser flange.
– Slide tension spring (3) over the condenser flange.
– Fasten condenser (1) to the drive (4) by tightening the coupling hand-
tight.
Laborota 4000/4001 efficient, 4010/4011 digital, 4002/4003 control
1.02