Initial Operation; Attaching The Heating Bath; Filling The Heating Bath - Heidolph Laborota 4000 efficient Betriebsanleitung

4.4 Initial operation

4.4.1
4.4.2
1.02

Attaching the heating bath

Place the instrument base in a suitable location.
Fig. 4-1: Heating bath
1. Place the feet of the heating bath in the tracks (1). Ensure that the controls
are facing forward.
2. If necessary, adjust the height of the feet.
– Loosen the feet by hand or with an open-ended wrench and adjust
them until the heating bath stands firmly without wobbling.

Filling the heating bath

The heating bath can be filled with a variety of liquid heating media.
When using to de-ionized or distilled water:
Add 0.2% borax (Na
The minimum/maximum volumes of the heating bath refer to the liquid level
with the evaporating flask immersed.
1. Select a liquid suitable for your application such as tap water, oil with a low
viscosity (40cP) and flash point (check safety data sheet) > 260 °C, water-
soluble polyethylene glycol.
2. Lower the evaporating flask.
3. Fill the heating bath with medium. The level must be between the
minimum and maximum marks.
Laborota 4000/4001 efficient, 4010/4011 digital, 4002/4003 control
B O *10 H O) to the water.
2 4 7 2
Setup and initial use
83