Cleaning And Maintenance; Cleaning; Maintenance; Storage - Parkside PHD 150 E4 Betriebsanleitung

Cleaning and

Maintenance

Pull out the power plug before eve-
ry maintenance operation. This also
includes connecting to the water
supply or trying to eliminate leaks.
There is a risk of electrocution or of
injury from moving parts.

Cleaning

Never direct the water jet
against the pressure cleaner,
nor clean the pressure clean-
er under flowing water. This
could give rise to the danger
of electric shock and damage
the pressure cleaner!
Always keep the pressure cleaner
clean. Do not use any detergents or
solvents.
• Always keep the ventilation slots clean
and free.
• Only clean the pressure cleaner with a
soft brush or a slightly moist cloth.
• If the standard Vario nozzle (24) is
soiled or blocked, you can remove any
foreign bodies in the nozzle using the
nozzle cleaning needle (23). Rotate
the nozzle tip to move the two metal
plates in the nozzle away from each
other. This enables you to reach the
water outlet opening with the nozzle
cleaning needle (23). Rinse the stand-
ard Vario nozzle with water to remove
the foreign body.
The nozzle cleaning needle (23) is
located in a slot on the housing on
the side of the bracket for the mains
cable above the wheel (13).
Maintenance
The pressure cleaner is maintenance free.
Ask our service centre to car-
ry out any work that is not
described in these instruc-
tions. Use only original parts.

Storage

• Drain all the water from the pressure
cleaner.
Disconnect the unit from the water sup-
ply. Press the On/Off switch (8) to turn
on the pressure cleaner for no longer
than 1 minute until no more water es-
capes from the jet gun(1) or from the
attaching parts (10/18/24). Turn off
the unit.
• Store all add-ons (10/18/24) verti-
cally with the connection side facing
downwards.
• Protect the pressure cleaner and its ac-
cessories from frost when they have not
been completely drained of all water.
• Store the pressure cleaner and its ac-
cessories in a frost-free room.
Waste Disposal
and Environmental
Protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
Electric appliances should not be
disposed of in the domestic gar-
bage.
Hand the tool in at a recycling centre. The
plastics and metal parts can be separated
and recycled. Ask your Service Center
about this.
GB
25