Trouble Shooting - Parkside PHD 150 E4 Betriebsanleitung

GB

Trouble shooting

Problem Possible cause
Standard Vario nozzle (24)
is soiled
Severe pres-
sure fluctua-
tions
Standard Vario nozzle (24)
is blocked
ON / OFF switch (8) is
turned off
Pressure
Damaged power supply
cleaner is not
cable
operating
Mains fault
Air trapped in the pressure
Pressure clean-
cleaner
er does not
generate any
Drop in the water mains
pressure
pressure
Connections not fitted cor-
rectly
Leaks in the
water system
Water connection (12) leaks
28
Remedy
Rinse the standard Vario nozzle (24)
with water. If required, clean the nozzle
bore hole with a needle (see chapter en-
titled cleaning).
Remove the Standard Vario nozzle (24)
and ensure that the water can discharge
from the jet gun (1) unimpeded. In other
words, the device is working perfectly.
The turbo dirt blaster (10) and the rotat-
ing wash brush (18) do not normally get
blocked.
Check ON / OFF switch (8)
Switch off the equipment and disconnect
from the mains. Check power supply
cable for damage. If necessary have the
power supply cable replaced by a quali-
fied electrician.
Check the electrical system for conform-
ity with the data on the rating plate.
Switch on the equipment with the jet gun
and with no nozzle until bubble-free wa-
ter comes out.
Check the water mains.
Switch off the equipment and disconnect
from the mains. Reconnect the equipment
to the water pipes (cf. "Initial Operation/
Set-Up")
Switch off the equipment and discon-
nect from the mains. Replace the water
connection (12) inc. gasket (cf. "Spare
Parts")