Ending Operation; Cleaning And Maintenance; Cleaning; Maintenance - Parkside PHD 110 D1 Originalbetriebsanleitung

GB IE

Ending operation

1. Release the switch lever (20) of the
spray gun (13).
2. Turn the pressure washer off using the
on/off switch (3).
3. Turn off the tap.
4. Press the switch lever of the spray gun
(13) to release the existing pressure in
the system.
5. Remove the mains plug.
6. Wind the mains connection cable (7)
around the retaining bracket for the
mains connection cable.
7. Disconnect the pressure washer from
the water supply.
Cleaning and

Maintenance

Pull out the power plug before
every maintenance operation. There
is a risk of electrocution or of injury
from moving parts.

Cleaning

Never direct the water jet
against the washer, nor clean
the washer under flowing
water. This could give rise to
the danger of electric shock
and damage the washer! .
Always keep the washer clean. Do
not use any detergents or solvents.
• Always keep the ventilation slots clean
and free.
• Only clean the pressure washer with a
soft brush or a slightly moist cloth.
• If the flat spray nozzle (11) is blocked,
you can remove any foreign bodies in
the nozzle using the nozzle cleaning
24
needle (14).
• Occasionally clean the filter insert un-
der running water.
Maintenance
The pressure washer is maintenance free.
Ask our service centre to carry out
any work that is not described in
these instructions. Use only original
parts.

Storage

• Drain all the water from the pressure
washer. Disconnect the unit from the
water supply. Press the On/Off switch
(3) to turn on the pressure washer for
no longer than 1 minute until no more
water escapes from the high-pressure
connection (9). Turn off the unit.
• Wind the mains connection cable (7)
around the retaining bracket for the
mains connection cable (2).
• Store the flat spray nozzle (11) in the
holder for the flat spray nozzle (6).
• Protect the pressure washer and its ac-
cessories from frost when they have not
been completely drained of all water.
• Store the pressure washer and its ac-
cessories in a frost-free room.
• To transport or put away the equip-
ment, use only the carrying handle.
• Ensure that the device is stored in an
upright position so that it is protected
against any damage.
Waste Disposal and
Environmental Protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.