Ending Operation; Using Detergents; Cleaning And Maintenance; Cleaning - Parkside PHD 135 C2 Originalbetriebsanleitung

Ending operation

1. After having worked with a detergent
rinse the pressure cleaner with clear
water.
2. Release the lever of the gun (9).
3. Turn off the pressure by its ON / OFF
switch (3). Disconnect the mains plug.
4. Turn off the water tap.
5. Disconnect the pressure cleaner from
the water mains.
6. Pull the lever of the gun (9) to vent the
pressure existing within the system.

Using detergents

Operate the standard Vario nozzle
(11) in low-pressure mode to auto-
matically add cleaning agent to the
water.
The pressure cleaner was designed for
operation with a neutral detergent based
on a biologically decomposable anionic
tenside. Other detergents or chemical sub-
stances could impair the safety of the pres-
sure cleaner and damage it. Such damage
to the equipment is not covered by the
guarantee. You can buy cleaning agents
( 27) from our online sho
Fill/drain detergent:
• To add cleaning agent (
jet, you must first fill the cleaning agent
tank ( 19)
• To remove the cleaning agent tank
( 19), hold it on the side and push it
upwards. You can now pull the clean-
ing agent tank out of the bottom and
side guides on the pressure cleaner.
Mind to first remove the induction hose
and the cap (
of the cleaning agent tank as they will
remain on the pressure cleaner.
• To reinstall the cleaning agent tank
( 19), trace back the above steps.
27) to the
18) from the opening
D
Working Instructions:
• Operate the standard Vario nozzle
(11) in low-pressure mode 2 to
automatically add cleaning agent to
the water.
Cleaning and
Maintenance
Pull out the power plug before eve-
ry maintenance operation. This also
includes connecting to the water
supply or trying to eliminate leaks.
There is a risk of electrocution or of
injury from moving parts.

Cleaning

Never direct the water jet
against the pressure cleaner,
nor clean the pressure clean-
er under flowing water. This
could give rise to the danger
of electric shock and damage
the pressure cleaner!
Always keep the pressure cleaner
clean. Do not use any detergents or
solvents.
• Always keep the ventilation slots clean
and free.
• Only clean the pressure cleaner with a
soft brush or a slightly moist cloth.
• If the standard Vario nozzle (
is soiled or blocked, you can remove
any foreign bodies in the nozzle using
the nozzle cleaning needle (
Rotate the nozzle tip to move the two
metal plates in the nozzle away from
each other. This enables you to reach
the water outlet opening with the noz-
zle cleaning needle (
standard Vario nozzle with water to
remove the foreign body.
GB IE
11)
12).
12). Rinse the
25