Arm Pad Height And Depth (Option 1); Arm Pad Depth (Option 2) - Vermeiren V300 Installationsanleitung

3.9

Arm pad height and depth (option 1)

This arm pad (see picture on next page) is adjustable in height and depth, each in 3
positions. The height is adjusted by adding or removing distance blocks. The depth is
adjusted by using different mounting holes.
To adjust:
1. Remove both socket screws (34).
2. Place the correct number of blocks below and above the frame tubes, see table 1.
3. For depth adjustment, install the arm pad by using the correct mounting holes, see table 2.
Table 1
Height arm pad to seat
220 mm (Default)
230 mm
240 mm
Table 2
Depth of the arm pad
Front position
Middle position (Standard)
Back position
3.10

Arm pad depth (option 2)

Adjust the depth of the arm pad as follow (range
120 mm: step less):
1. Loosen both socket screws (35) at the bottom
of the arm pad.
2. Move the arm pad to the front or rear within
the range of the slotted holes (42,5 mm).
If this not enough, loosen the socket screws
and attach the arm pad using the other holes
(3 positions available).
3. Tighten both socket screws firmly.
4. Repeat this for the second arm pad. Make sure both arm pads are positioned identically.
Number of blocks
below tube
2
1
0
Used holes
Back and middle
Hole 2 and 4
Front and middle
34
Installation manual
- 15 -
V-series wheelchairs
Adjustments
Number of blocks
between tube and arm pad
1
2
3
EN
NL
2018-10
PL
CS
35