Adjusting Rear And Front Wheel Height - Vermeiren V300 Installationsanleitung

EN
NL

3.3.2 Adjusting rear and front wheel height

Adjust the rear-wheel height as follows:
1.
Remove the rear wheels (see instruction manual).
PL
2. Demount the axle housings (E) of the rear wheels from axle
plate (D) and remount in the correct hole, see tables in §3.3.1.
CS
3. Repeat this for the second rear wheel. Make sure both housings
are positioned identically.
4. Verify that both axle housings (E) are tightened firmly.
Adjust the front wheel height as follows:
1. Remove the cover cap from the frame tube.
2. Remove the nut (31) of the swivel axle (F) and collect the loose parts.
3. Demount the front wheel and remount it in the correct hole of front fork
(A) according to the tables in §3.3.1.
4. Verify that the location of the bushing (B) is correct in relation to the
swivel-axle housing (C), see tables in §3.3.1.
5. Mount the swivel axle (F) back in the housing (C) with bushing (B) at
the correct position, see the exploded view. Tighten nut (31) firmly.
6. Check the tension of the swivel axle (F); make sure it turns smoothly,
without play.
7. Repeat this for the second front wheel. Make sure both front wheels are
positioned identically.
Final adjustment
1. Insert the rear wheels.
2. If installed properly, the swivel axles of the front wheels stand
perpendicular to the ground. To adjust the angle of the swivel axles,
follow the instruction in next section.
3.
Finally, adjust the brakes according to the instruction in § 3.4.
Installation manual
- 8 -
V-series wheelchairs
2018-10
Adjustments
1
3
2
4
D E
31
C
B
F
A