Adjustment Of Cross And Backrest Connection; Seat Depth Option 1; Seat Depth Option 2 - Vermeiren V300 Installationsanleitung

EN
NL

3.4.2 Adjustment of cross and backrest connection

The settings and item numbers can be found in following sections
PL
Cross position (if adjustable)
CS
1. Remove clip (10), at each side of the wheelchair.
2. Move the cross (X) forwards/backwards to the desired position according to the settings
in the tables of previous sections.
3. Replace both clips (10) at each side of the wheelchair to lock the cross position.
Backrest-connection position
1.
Demount both socket screws of the backrest connection, at both sides of the wheelchair.
2. Move the backrest connection (A/B/C/D) forwards/backwards to the desired position
according to the settings in the tables of previous sections.
3. Mount the 2 socket screws firmly; at both sides of the wheelchair.
4. Verify if seat height and seat angle are correctly set.

3.4.3 Seat depth option 1

This type of wheelchair is only adjustable in 3 seat
depths by adjusting the backrest connection (A).
V300XL

3.4.4 Seat depth option 2

This type of wheelchair is adjustable in 5 seat depths by adjusting the location of the frame
cross (X) and backrest connection (B), see picture on next page.
V300 30°
Seat depth
position holes
490 mm
(Default)
510 mm
530 mm
Cross position
Seat depth
460 mm Hole 1 and 3
440 mm (Default) Hole 2 and 4
500 mm Hole 1 and 3
480 mm Hole 2 and 4
520 mm Hole 1 and 3
Installation manual
Backrest
1
2
3
Backrest
holes position holes
1
1
2
2
3
- 10 -
V-series wheelchairs
2018-10
Adjustments
A
1 2 3