Unit Mounting And Cooker Hood Wiring - SystemAir SAVE VTR 150/B Betriebs- Und Wartungsanleitung

GB
• The cooker hood is attached to the wall using included mounting brackets. Using this alternative method, a flexible
duct to connect the cooker hood and the unit must be used since it will be impossible to insert the cooker hood di-
rectly into the unit.
Follow instructions delivered with the cooker hood how to prepare it before installation.
1. Place a circular insulation on the cooker hood connector to prevent air leaking (figure 7, pos. 2).
Insert the cooker hood directly into the unit (figure 7, A). Screw the cooker hood to the bottom of the SAVE VTR 150/
B unit (figure 7, pos. Y). The duct connector have to go into the unit. Make sure the duct connector is aligned with the
unit before starting (figure 7, pos. X). Use included screws and plastic spacers to prevent over-tightening which could
lead to bent cooker hood (figure 7, pos. 1).
2. Other installation method is to connect the cooker hood to the unit via a flexible duct (figure 7, B). Use mounting
mechanism which is delivered together with the cooker hood (figure 7, pos. Z).
6.2.3

Unit mounting and cooker hood wiring

1. Pull the cooker hood power supply and control cables to the top since the mounted SAVE VTR 150/B unit will block
access to the back.
2. Once all cooker hood cables at the back are led to the top, lift the unit and hang it on the mounting bracket.
212024 | A001
Fig. 7 Installation of the cooker hood
Fig. 8 Placing the unit on the mounting bracket (the cooker hood is not shown)
15
Installation |