392-10/B Cooker Hood Installation - SystemAir SAVE VTR 150/B Betriebs- Und Wartungsanleitung

GB
2. Screw the mounting bracket (pos. 1) with the anti-vibration pad (pos. 2) to the wall (figure 12, pos. A). Screws are
not included, choose them based on your wall type. Use appropriate holes to screw the bracket firmly to the wall.
Bottom side of bracket should be 40 mm (H) below top of unit position.
Leave 15 mm gap between the mounting bracket and the cupboard for the cooker hood wires.
Note:
Make sure that the mounting bracket is completely horizontal once mounted on the wall. Check with a spirit
level.
In case the depth of cabinets is much greater than the unit, install wooden blocks (pos. W) to compensate the missing
distance (figure 12, pos. B). Then install the mounting bracket on the upper block. Choose thickness of blocks according
to your needs.
Thickness of wooden blocks should be 25–100 mm. If needed distance is lower than 25 mm, adjust bolts instead of us-
ing wooden blocks (see figure 20).
Caution
Be sure to select the appropriate type and length of the screws so that they could hold additional wood
blocks and the unit itself.
6.3.2 392–10/B cooker hood installation
Product name and number
• 392-10/B Slimline — 77265
The cooker hood must be attached to the sides of cupboards or directly to the SAVE VTR 150/B unit first before it can
be mounted on the wall because cooker hood power supply and control cables at the back must be led to the top and
already mounted SAVE VTR 150/B unit will block access.
There are two options how to install the cooker hood:
• The cooker hood is attached directly to the bottom of the unit. This option can be used when the whole unit with a
cooker hood will be shifted forward using wood blocks to be alighted with the cupboards or when the cupboard size
matches the unit and no adjustments are needed. This way the unit can be simply mounted directly on the wall with
already attached cooker hood.
• The cooker hood is attached to the sides of cupboards using included brackets. If the unit and cooker hood is not
aligned, a flexible duct must be used since it will be impossible to insert the cooker hood directly into the unit.
Follow instructions in the manual delivered with the cooker hood.
212024 | A001
Fig. 12 Installation of mounting bracket without or with wooden blocks
19
Installation |