Save Vtr 150/B - SystemAir SAVE VTR 150/B Betriebs- Und Wartungsanleitung

24
| Installation
Number Explanation
1
Wall or any other mounting surface
2
Wood block (if needed, 25–100 mm)
3

SAVE VTR 150/B

4
Adjustable bolts (15–25 mm)
5
Kitchen furniture panel (P)
Adjust bolts if shifting distance is less than 25 mm or use wood blocks in case the required distance is greater.
1. Install four M6 bolts into threaded inserts on the unit and lock bolts with hex nuts (figure 20). Bolts protrusion can be
adjusted later.
A cross screwdriver and a 10 mm spanner are needed. They are not included in the package.
2. Sticker with marked holes (figure 21, pos. 1) is included with the unit. Holes mark spots for screws to secure hooks.
Place the sticker on a back of the kitchen furniture panel, figure 21, pos. 2), adjust position of the sticker according to
the panel size and position of the unit between cabinets. Size of the sticker is the same as the unit.
Once correct position is found, attach four hooks (figure 21, pos. 3) by fastening each with two screws (figure 21,
pos. 4). Hang the kitchen furniture panel on protruding bolts (figure 21, pos. A).
Fig. 20 Installation of bolts
Fig. 21 Installation of hooks and mounting of the kitchen furniture panel
GB
212024 | A001