Important Safeguards For Electrical Appliances - Gastroback 42539 Bedienungsanleitung

• Do not leave any food dry on the appliance. Always clean the appli-
ance after each use to prevent an accumulation of baked-on food
(see: 'Care and Cleaning'). Always keep the appliance and its parts,
where it is clean.

IMPORTANT SAFEGUARDS FOR ELECTRICAL APPLIANCES

The appliance is heated electrically. Place the appliance near a suita-
ble wall power outlet to connect the appliance directly to a protected
mains power supply with protective conductor (earth/ground) connected
properly. Ensure that the voltage rating of your mains power supply cor-
responds to the voltage requirements of the appliance (220 - 240 V,
50 / 60 Hz, AC, rated for at least 16 A). The power outlet socket must be
installed separately from other power outlet sockets to avoid interference
with other appliances.
The installation of a residual current operated circuit breaker (r.c.c.b.)
with a maximum rated residual operating current of 30 mA in the supp-
lying electrical circuit is strongly recommended. If in doubt, contact your
electrician for further information.
• In various foreign countries, the specifications for power supplies are
subject to incompatible norms. Therefore, it is possible that power sup-
plies in foreign countries do not meet the requirements for safe opera-
tion of the appliance. Thus, before operating the appliance abroad,
ensure that safe operation is possible. Do not use any desk top multi
socket outlet, external timer, or remote control systems.
• It is best to avoid using an extension cord, but if you wish to use one,
ensure that it is of sufficient length and rated for a maximum continuo-
us current of at least 16 A with safety plug, safety coupler plug, and
protective conductor (earth/ground) connected properly.
• When laying power cords, always ensure that no one will step on
the power cord or get entangled or trip over the power cord. Also,
ensure that no tension is applied to any part of the power cord. Tie
the extension cord loosely onto the leg of the table using a separate
cord, to ensure that no one will pull the power cord. To disconnect:
Always unplug the extension cord from the power supply first.
54