Cleaning The Appliance - Gastroback 42539 Bedienungsanleitung

CLEANING THE APPLIANCE

1. Before cleaning, always ensure that the appliance is unplugged, and cooled
down to room temperature. Then disassemble the appliance (see: 'Operation /
Disassembling the Appliance'). Clean the drip tray, storage tray, inner tray, and
grilling plates in warm dishwater via a soft nylon brush.
Note
You may clean these parts in an automatic dishwasher. Place the plastic parts
onto the upper rack.
CAUTION:
Do not pull or bent the cable of the temperature probe. For soaking stubborn resi-
dues, only immerse the tip of the temperature probe.
The heating elements on the grilling plates must be completely clean, when using
the appliance for the next time. Otherwise, residues of food could burn to char-
coal, give off smoke, or even catch fire!
2. Wipe the temperature probe (tip, handle, and cable) using a soft cloth moiste-
ned with warm dishwater. Stubborn residues on the tip of the temperature pro-
be may be soaked. For this, fill some warm dishwater into a small cup or mug
with a little dishwater and immerse only the tip of the temperature probe for
approx. 10 minutes. Thereafter, wipe the tip with a soft damp cloth.
3. Slide the height control clip to the "OPEN" position and lift the lid to the upright open
position (see: 'Properties of Your New Contact Grill / Locking the Lid to the Base').
4. Wipe the exterior of the appliance using a damp cloth. Always ensure not
to drip water into the interior or onto the front plate of the appliance. Check,
whether the heating chambers (during operation below the grilling plates) are
completely clean. If required, carefully remove any residues via a damp cloth to
avoid burning in any residues, when using the appliance next time.
5. Thoroughly dry all parts of the appliance after cleaning. Then, leaving the lid of
the appliance in the upper open position, let all parts dry naturally for approx.
30 minutes, with all parts out of reach of young children.
6. After cleaning, reassemble the appliance to avoid loss and damage to the parts
(see below: 'Assembling the Appliance').
82
Do not immerse the temperature probe or its cable in any liquids.