Important Safeguards For Electrical Appliances - Gastroback HEALTH SMART GRILL PRO Bedienungsanleitung

moving, or cleaning the appliance, or assembling or disassembling any parts, or
when the appliance is not in use. Do not place any hard and/or heavy objects
on the appliance or any part of it.
• Do not use any abrasive cleaners, cleaning pads (e.g. metal scouring pads), or
any corrosive chemicals (e.g. bleach) for cleaning.
• Do not place the housing or the power cord in an automatic dish-
washer.
• Do not leave any food dry on the appliance. Always clean the appliance after
each use to prevent an accumulation of baked-on foods (see: »Care and Clea-
ning«). Always keep the appliance and its parts, where it is clean.

IMPORTANT SAFEGUARDS FOR ELECTRICAL APPLIANCES

The appliance is heated electrically. Place the appliance near a suitable wall power
socket to connect the appliance directly to a protected mains power supply with pro-
tective conductor (earth/ground) connected properly. Ensure that the voltage rating
of your mains power supply corresponds to the voltage requirements of the appli-
ance (220-240 V, 50 Hz, AC, rated for at least 16 A). The power outlet socket must
be installed separately from other power outlet sockets to avoid interference with
other appliances.
The installation of a residual current operated circuit breaker (r.c.c.b.) with a maxi-
mum rated residual operating current of 30 mA in the supplying electrical circuit is
strongly recommended. If in doubt, contact your electrician for further information.
In various foreign countries, the specifications for power supplies are subject to
incompatible norms. Therefore it is possible that power supplies in foreign countries
do not meet the requirements for safe operation of the appliance. Thus, before ope-
rating the appliance abroad, ensure that safe operation is possible.
• Do not use any desk top multi socket outlet, external timer, or remote control sys-
tems. It is best to avoid using an extension cord, but if you wish to use one, only
use an extension cord rated for a maximum continuous current of at least 16 A
with safety plug and safety coupler plug and protective conductor (earth/ground)
connected properly. Additionally, the extension cord must be of sufficient length.
• When laying power cords, always ensure that no one will step on the power
cord or get entangled or trip over the power cords. Also, ensure that no tension
is applied to any part of the power cords. Tie the extension cord loosely onto the
leg of the table using a separate cord, to ensure that no one will pull the power
cord. To connect: always connect the appliance to the extension cord first. To dis-
connect: Always unplug the extension cord from the power supply first.
• Always handle power cords with care. The pins of the power plug must be smooth
34