Important Safeguards For Electrical Appliances - Gastroback DESIGN BBQ PRO Bedienungsanleitung

rages. Alcohol will quickly evaporate due to the heat, thus building an
inflammable mixture that could be ignited by any source of ignition
(e.g. candles, cigarettes, and heating elements of the appliance), cau-
sing severe injuries to persons and serious damage. DO NOT heat any
high-proof alcoholic liquid or alcoholic foodstuffs (e.g. mulled wine,
grog) on the appliance. Do not pour any alcoholic liquid on the appli-
ance to avoid risk of explosion and fire. The appliance is NOT suited
for flambéing.
• Do not leave the appliance unattended, when it is connected to the
power supply. Always unplug the appliance, and leave the appliance
cool down, before moving, or cleaning the appliance, or assembling
or disassembling any parts, or when the appliance is not in use. Do not
place any hard and/or heavy objects on the appliance or any part of it.
• Do not use any abrasive cleaners, cleaning pads (e.g. metal scouring
pads), or any corrosive chemicals (e.g. bleach) for cleaning. Do not place
the housing or the power cord in an automatic dishwasher.
• Do not leave any food dry on the appliance. Always clean the appli-
ance after each use to prevent an accumulation of baked-on foods (see:
'Care and Cleaning'). Always keep the appliance and its parts, where it
is clean.

IMPORTANT SAFEGUARDS FOR ELECTRICAL APPLIANCES

The appliance is heated electrically. Place the appliance near a
suitable wall power outlet to connect the appliance directly to a protected
mains power supply with protective conductor (earth/ground) connected
properly. Ensure that the voltage rating of your mains power supply cor-
responds to the voltage requirements of the appliance (230 V, 50 Hz,
AC, rated for at least 16 A). The power outlet socket must be installed
separately from other power outlet sockets to avoid interference with other
appliances.
The installation of a residual current operated circuit breaker (r.c.c.b.) with
a maximum rated residual operating current of 30 mA in the supplying
electrical circuit is strongly recommended. If in doubt, contact your electri-
cian for further information.
40