Gastroback 42539 Bedienungsanleitung Seite 70

tions') near a suitable wall power outlet (see: 'Important Safeguards for Electrical
Appliances'). On each side and to the edge of the working surface, keep at least
50 cm of free space. However, if you wish to place food on the grilling surface
of the lid as well, leave at least 80 cm of free space at the rear of the appliance.
WARNING:
the appliance to the power supply. Do not operate the appliance with the power
cord wrapped around the cord storage to avoid damage and injuries due to over-
heating and short circuit. Slide the height control clip on the right side of the lid
support to the "OPEN" position (see: 'Locking the Lid to the Base'). Open the lid
and ensure that the grilling surfaces are clean and there are no foreign objects on
it. Ensure that the grilling plates and drip tray are assembled correctly (see: 'Care
and Cleaning / Assembling the Appliance'). The front plate of the drip tray may
not protrude the side of the base. Before first use of the appliance and after clea-
ning the grilling plates in an automatic dishwasher: Wipe the grilling surfaces
with a little cooking oil once to prepare the non-stick coatings for usage.
3. Close the lid, even if you wish to use the appliance with the lid folded back.
With the lid closed, the grilling surfaces will reach the desired cooking tempera-
ture quickly, and without useless energy loss. For using the temperature probe:
On the left side of the control panel, pull out the storage tray and remove the
inner tray from the storage tray, holding the temperature probe. Below the front
plate of the storage tray, the probe connector of the temperature probe is acces-
sible. Insert the plug of the temperature probe here and place the temperature
probe beside the appliance.
CAUTION:
faces, when the appliance is hot. Do not place the temperature probe on the grilling surface!
Note
When using the temperature probe, we recommend to hold a clean and heat-resi-
stant coaster or flat bowl at hand for placing the temperature probe on it, while
it is not in use. You may use the inner tray of the temperature probe. Additionally,
it is a good idea to hold a clean, damp cloth at hand for wiping the tip of the
temperature probe immediately after each measurement.
4. Insert the power plug in a suitable wall power outlet (see: 'Important Safeguards
for Electrical Appliances'). A signal sounds an "OFF" flashes on the touchscreen.
5. Press the ON/OFF button to switch on the appliance. The grilling temperature
flashes on the display area of the touchscreen. At the left side of the grilling tem-
perature, the grilling time is shown ("00 M").
70
Always completely unwind the power cord before connecting
Handle and cord of the temperature probe may not touch the grilling sur-