Assembling The Appliance - Gastroback 42539 Bedienungsanleitung

ASSEMBLING THE APPLIANCE

7. Ensure that the height control clip is in the "OPEN" position and fold up the lid
to the stable upright position.
8. Check, whether the heating chambers of lid and base (during operation below
the grilling plates) as well as the grilling plates are completely clean. Residues
within the heating chambers or on the grilling plates would burn to charcoal
during operation. If required, clean the heating chambers and grilling plates (see
above: 'Cleaning the Appliance').
Important: The grilling plates cannot be exchanged by each other. When moun-
ted in the appliance, the drip spouts of each grilling plate must face to the rear
left side of the appliance. All parts of the appliance can be installed without app-
lying any force!
9. With the drip spouts facing to the rear of the appliance, carefully slide the notches
in the grilling plates into the clamps near the lid hinge. Then press the front part of
the grilling plate against the base / lid for engaging the lock of the grilling plates.
10. Insert the drip tray in the opening at the left side of the housing of the appliance
and push the drip tray into position. The front plate of the drip tray may not pro-
trude the side plate of the appliance.
11. Close the lid and slide the height control clip to the "LOCK" position. Ensure that
lid and base of the appliance are locked together securely.
12. For placing the appliance aside and for storage: Insert the temperature probe
into the groove at the left side of the smaller inner tray of the temperature pro-
be and carefully press the tip of the temperature probe down until it snaps into
place. Then wrap the cable of the temperature probe loosely around the cable
support of the inner tray. Push the plug into the inner tray gently.
13. Place the inner tray into the storage tray and push the storage tray into the ope-
ning in the control panel of the appliance.
Tip: If you find it difficulty to re-place the temperature probe in the inner tray and/
or the storage tray in the appliance, you may leave the inner tray aside, but install
the storage tray in the control panel without the temperature probe for protecting
the probe connector. Store the temperature probe with the appliance.
83