Adjusting The Headlight - Betamotor ALP 4.0 Bedienungsanleitung

4

ADJUSTING THE HEADLIGHT

• The headlight beam is adjusted manually after loosening the screws on either side
of the headlight with an Allen key.
• Periodically check the direction of the beam. The beam can only be adjusted
vertically.
• Place the vehicle on level ground (but not on the stand) 10 metres from a vertical
wall.
• Measure the height of the headlight centre above the ground and then draw a
cross on the wall at 9/10 of the height of the headlight centre.
• Turn on the low beam, get on the motorbike and check that the headlight beam on
the wall is slightly lower than the cross drawn previously.
GB
10 m
148