Carburetor; Battery - Betamotor ALP 4.0 Bedienungsanleitung

3

CARBURETOR

To ensure optimum carburetion, it is essen-
tial to carefully clean the carburetor.
Remove the carburetor from the vehicle.
Unscrew the two fixing screws A and re-
move the float chamber. Check that the
float is properly positioned by verifying that
float holder plate is parallel with the
carburetor body surface as shown in the
figure. Also check that the jets are clean.
WARNING:
These descriptions are purely informative.
We suggest that you revert to a
BETAMOTOR authorized mechanic.

BATTERY

Check if battery is charged by measuring
the voltage with a voltmeter while the bat-
tery is at rest (engine off). The voltage must
not be less than 12.8 V.
In case of discharged battery, use an ex-
ternal battery's loader; disconnect the bat-
tery (if possible remove it from the vehicle)
and recharge it following the instructions
"to go on road" of the two-wheeler.
GB
132