Headlight; Replacing The Headlight Bulbs; Tail Light - Betamotor RR 350 Bedienungsanleitung

4

HEADLIGHT

Keep the headlight glass clean at all times
(see page 59).
Periodically check the correct angle of the
light beam.
REPLACING THE
HEADLIGHT BULBS
2
Release both spring washers and move
forward the lamp holder front cowl.
Carefully remove the headlight bulb 1
together with lamp holder. To replace the
high beam / low beam, lift the rubber
cover 2, release connector, push on the
1
spring 3 and remove the lamp holder and
replace the light bulb with a new one. Be
careful not to touch the bulb so as not to
3
compromise its effi ciency.
To refi t, follow the procedure above but in
reverse order.
Fasten the lamp holder front cowl to the
supporting pins and fi x it with the two
elastics.

TAIL LIGHT

Keep the tail light glass clean at all times
(see page 59).
The LED tail light is sealed. In the case of
burnout of one or more LEDs it is necessary
to replace the entire group.
To replace, contact authorised Betamotor
customer service.
GB
55