Running-In - Betamotor ALP 4.0 Bedienungsanleitung

RUNNING-IN

The running-in period lasts approximately
10 hours, during which it is advisable to:
• Warm up the engine well before starting
off.
• Avoid riding at constant speed (chang-
ing the speed allows the different com-
ponents to bed in uniformly and in a
shorter time).
• Avoid turning the throttle twist grip more
than 3/4 of its travel.
WARNING:
After the first 1000 km renew the engine
oil.
IMPORTANT:
It is necessary to make sure that after run-
ning for 1000 Km., the metallic filter, posi-
tioned on the final part of the oil tank, is
clean (see page 120). If it should not be
clean, use compressed air to clean it.
• Always use high-octane unleaded petrol.
• After using the vehicle on rough ground
for the first time, carefully check the
tightening of all nuts and bolts.
113
2
GB