Power Booster (Optional); Remote Start (Optional); Speaker Output (Optional) - Sentiotec home.com4 Montage- Und Gebrauchsanweisung

Installation instructions, only for experts

5.10. Power booster (optional)

1. Feed the cable for the power booster through cable gland a into the con-
nection area for 230 V/400 V.
2. Connect the cable for the power booster to terminal strip h in ac-
cordance with the connection diagram. To do so, use terminal
"ST1" for the safety circuit, and terminal "ST2" for the control circuit.
Observe the operating instructions for the respective device.

5.11. Remote start (optional)

This is connected using the terminals "RS1", "RS2"
and "24VDC" on terminal strip f.
Using a switch or an actuator, the +24 VDC must be
switched to the terminal for the desired operating
mode, RS1 or RS2.
In the technician menu, RS1 and RS2 can be as-
signed to any operating mode or user program
(see "10.16. Activating standby for remote op-
eration" on page 50).

5.12. Speaker output (optional)

The loudspeaker output can be used to connect commercially available loud-
speakers with a recommended music load of approx. 25 W. The impedance
should be 8 Ω. The minimum cross-section of the speaker cables is 2 x 0.5 mm².
1. Feed the wires for the loudspeaker through the cable gland 7 into the
low-voltage connection area on the expansion module.
2. Connect the loudspeaker wires to terminal strip f labelled RS- and RS+
for the right speaker and LS- and LS+ for the left speaker. For an optimal
sound experience, observe the polarity of the connecting cables.
p. 24/64
Fig. 6 Remote start