Activating Standby For Remote Operation - Sentiotec home.com4 Montage- Und Gebrauchsanweisung

Instructions for use for the user

10.16. Activating standby for remote operation

EN 60335-2-53 specifies that sauna control units with a remote start
function must be set manually to "Standby for remote operation" mode.
This activation must take place again after each remote start and stop
procedure.
Starting standby for remote operation:
● Use rotary selector 1 to select the remote start icon. Then press it
briefly to start the operating mode "Standby for remote operation".
► The sauna control unit switches off all previously activated func-
tions and the remote start icon appears on the display.
► The sauna control unit is then ready to be started and stopped
using a remote start signal. It is not possible to manually operate
the sauna control unit at the same time.
► After a remote start and stop, the remote start icon goes out and
the mode has to be activated again.
Cancelling standby for remote operation:
● To deactivate standby for remote control, press rotary selector 1
and at the same time turn it to the right.
p. 50/64