Charge Output 2: "Out 2 Data; User Settings - ROBBE Power Peak E1 Bedienungsanleitung

11. Charge output "Out 2 data"
Charge output 2 "Out 2 data" is designed for
recharging receiver or transmitter batteries
at currents of up to 2 A.
The battery parameters are defined using
the three set-up points battery type, charge
current and capacity.
At this output there is no facility for balan-
cing Lithium packs or discharging batteries.
The charge process is started or interrupted
by pressing the "OUT 2" button.
This output also features a sub-menu which
sing Enter again closes the window.
Cell count:
1 ... 8 cells NC / NiMH
1 ... 3 cells LiPo (3.7 V)
1 ... 4 cells LiFe (3.3 V)
Charge current: 0.1 ... 2 A
Caution:
Do not connect any battery to Output 2 if
its cell count is higher than stated above.
Operating instructions
Power Peak E1
can display the bat-
tery voltage in curve
form. To see this,
move the cursor to
the second line and
press Enter; pres-

12. User settings

The charger includes a "User settings"
menu which contains many functions desig-
ned to ensure that its features can be set up
to suit any user.
One of those functions is the ability to select
any one of six menu languages.
Save / Copy
This function is used for saving (storing)
battery data during charge and discharge
processes.
If you leave both functions set to "No", the
data is sent to the USB port, so that it can
be displayed and saved using Logview PC
software.
The charger features an internal data
memory which records the information so
that it can be written to the PC and saved
later. If you wish to do this, Save must be set
to "Yes", and Copy to "No".
If you wish to read out the internal memory
later, you must set Save to "No" and Copy to
"Yes". Only then is the data passed to the
USB interface.
Note:
The data is stored inside the charger until
such time as a charge or discharge process
with another battery is initiated; at that point
the memory is overwritten.
15
Order No.
8471