Specification - ROBBE Power Peak E1 Bedienungsanleitung

SELECT wheel
All the menu parameters can be
adjusted by rotating the Select
wheel or dial.
Enter button
The "ENTER" button is pressed to confirm a
selection, e.g. to activate a selected menu,
or to accept a newly adjusted value.
OUT 1 and OUT 2 buttons
These buttons initiate the charge process at
the appropriate output. Repeatedly pressing
the OUT1 button activates the charge,
discharge or cycle functions for that output.
Pressing the OUT2 button simply starts the
charge function.
4.

Specification

Operating voltage:
Max. current drain:
Charge termination process:
NC / NiMH:
Lead-acid / Lithium:
Dimensions:
Output 1 (OUT1)
Cell count:
Charge current:
Discharge current:
Equalizing current:
Trickle charge:
Final discharge voltage:
Functions:
Operating instructions
Power Peak E1
Piezo buzzer and LEDs
The piezo buzzer emits an audible alert to
confirm every button-press, to indicate the
end of a charge or discharge process, and
to warn you of an error. The buzzer can be
set up in the User menu.
The LEDs adjacent to the buttons light up
every time the corresponding button is pres-
sed.
10 - 15 V (car battery) or 13.8 V mains PSU, min. 30 A
(do not use a car battery charger!)
approx. 37 Amps
Automatic, digital Delta-Peak system
Automatic, voltage-dependent, CC - CV process
170 x 175 x 85 mm
1 ... 36 cells NC / NiMH,
1 ... 14 cells LiIo (3.6 V), LiPo (3.7 V), LiFe (3.3 V)
1 ... 12 cells (2 ... 24 V) Lead-acid
1 ... 14 Special battery (see Section 13, page 17)
Auto, 0.1 ... 20 A (max. 315 W)
Auto, 0.1 ... 40 A (max. 160 W)
approx. 220 mA
C/20, NC and NiMH only
0.5 - 1.1 V / cell, NC and NiMH
2.5 - 3.6 V / cell, LiPo, LiIo, LiFe
1.8 V / cell, Lead-acid
Charge, discharge, discharge-charge, balance
6
Up / Down buttons
In manual mode these buttons are
used to increase or reduce the para-
meter values by one increment; at the
menu select stage they select the next
or previous menu.
Holding the buttons pressed in has the
effect of repeating the function auto-
matically; the rate of change increases
if the button is held pressed in for a
long period.
Order No.
8471