Installing The Computer Module - G&D DP1.2-Vision-Fiber Installation Und Bedienung

Installing the computer module

The computer, whose signals are transmitted to the remote console, is connected to
the
DP1.2-Vision-Fiber-CPU
the computer module.
Establishing a connection to a local network
NOTE: If desired, connect the network interface to a local network. This enables
you to access the Config Panel
log messages to this network.
Insert a category 5 twisted pair cable (or better), which is available as acces-
Network:
sory. Connect the other end of the cable to the local network.
Connecting keyboard and mouse to the local computer
USB 2.0 Trans. USB 2.0 CPU
Transmission DP Out DP CPU
NOTE: Mouse and keyboard signals of both consoles can either be transmitted to
the computer using the USB interface USB CPU or using the PS/2 interfaces Mouse
CPU and Keyb. CPU PS/2.
USB CPU: Use the USB-AM/BM-2 cable to connect one of the computer's USB inter-
faces to this interface.
Keyb. CPU: Use an optionally available PS/2 cable (PS/2-M/M-2) to connect the
computer's PS/2 keyboard interface to this interface.
computer module. If desired, connect a local console to
Power
Network
Red. Ident. K/M
Main Status
web application from this network and to send sys-
Keyb./Mouse
In Line Out USB CPU Keyb. CPU
Ch. Status Service
1
RS232
Red. Power
G&D DP1.2-Vision-Fiber · 8
Installation
Fan In