Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
NOUVAG AG
Insure that „pressure" tube runs to irrigation needle, and „suction" tube runs to
solution bottle!
10) Insert tube needle and hang cooling flask on hanger rod.
11) Open tube clamp.
12) Open air valve of the drip chamber.
13) Connect the mains cable into the electrical outlet.
Check for correct operation voltage and verify mains voltage output!
4.2 Tubing assembly-Internal irrigation
1)
Insert internal irrigation needle (1) into the end of the
tubing.
2)
Attach clip (2 & 3) to irrigation tubing.
3)
Insert irrigation needle into contra angle.
4)
Attach clip to contra angle and to motor cable.
5)
When necessary, attach additional clips to motor cable.
4.3 Tubing assembly–External irrigation
1)
Attach clip (1 & 2) to irrigation tubing.
2)
Connect piece of tubing to irrigation needle (3).
3)
Attach clip to contra angle and to motor cable.
4)
When necessary, attach additional clips to motor
cable.
4.4 Tubing assembly-combined
1)
Attach Y-connector (1) to the end of the tubing.
2)
Attach two 16cm pieces of tubing (2) to Y-connector.
3)
For internal irrigation, connect first tubing piece to
irrigation needle (3).
4)
Attach clips (4 & 5) to irrigation tubing.
5)
Attach irrigation tubing with clip to contra angle and to
motor cable.
6)
Insert irrigation needle into contra angle.
7)
Connect second tubing piece with external irrigation.
8)
When necessary, attach additional clips to motor cable.
No. 31820 22/07
230
2
1
3
1
4
3
MD 10
3
2
5
1
2
5
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
