Operation - Kärcher SB MU 908 Originalbetriebsanleitung

Symbols on the plant
Risk of electric shock!
Only electricians or authorised
technicians are permitted to
work on parts of the plant.
DANGER
Danger of injury by the high pressure jet.
Do not point the high pressure jet towards
humans or animals.
Risk of injury due to electric shock. Do not
point the high pressure jet towards electri-
cal appliances, cable and this equipment.
Hearing protection
The sound level in the plant amounts to 65
dB(A). If parts (such as large sheets) that
amplify sound are shot blasted, it can give
rise to higher noise levels. If so, wear ear
plugs.
Behaviour in emergency situations
 Turn the programme selection switch at
the operating panel to "STOP".
Proper use
This SB washing system is to be used for
cleaning
– Vehicles and
– Trailers
with water and detergents added to it.
It is wrong and therefore prohibited to use
the plant for cleaning
– human beings and animals. There is a
high risk of injury due to the high pres-
sure jet.
– Loose parts. These can get thrown off
due to the high pressure jet and can
cause damage to persons or other parts
of the plant.
To disconnect from the drinking water net-
work, a system separator type BA, catego-
ry 4 must be installed between the system
and the drinking water network. In addition
to that, the local regulations must be ad-
hered to.
ATTENTION
Risk of damage to the plant if water supply
is not of suitable quality.
ATTENTION
The system is frost-safe up to -20°C under
the conditions outlined in "frost-protection"
and must be brought to a stand-still if the
temperatures fall lower than this limit.
Workstation
– Coins are thrown in at the control panel
and the washing programme is select-
ed.
– Cleaning is done using the hand-spray
gun.
DANGER
Risk of injury, risk of burns. Carry out wash-
ing operation only when the plant is closed.
– The utility room of the plant may only be
accessible for instructed personnel for
maintenance purposes. The door must
be closed when the plant is in opera-
tion.

Operation

Switch-off in case of emergency
 Turn the programme selection switch at
the operating panel to "STOP".
Washing programmes
The following washing programs are avail-
able:
2
-
EN
Standard programmes
Stop
Interrupts the programme.
Basic position, washing tools in the tool
holders.
NOTICE
STOP function is active in all switch posi-
tions without washing programme.
High-pressure wash
Removes coarse dirt.
Warm water with shampoo
Distance of high pressure nozzle approx 30 cm.
Foam Wash
Deep cleaning with active foam.
Only use foam brush when the programme
is running and after the high-pressure
wash.
Rinse
Rinse off shampoo and foam.
Distance of high pressure nozzle approx 50 cm.
Hot wax
Warm water with paint protection.
Use after rinsing.
Distance of high pressure nozzle approx 80 cm.
Schaumpolish
Paint preservation with foam wax.
Only use the foam brush while the pro-
gramme is running.
Top care
For Spot-free drying.
Demineralised water leaves a spot-free
high gloss finish.
Distance of high pressure nozzle approx 80
cm.
Additional programmes (option)
Dirt Loosening
Removes persistent dirt.
Warm water with special detergent.
Distance of high pressure nozzle approx 30 cm.
Micro-emulsion (intensive cleaning
complete)
Removing bitumen road coating residue.
Spraying a special detergent.
Insects Loosening
Loosens insects.
Warm water with special insect removing
detergent.
Distance of high pressure nozzle approx 30 cm.
Wheel Cleaning
Loosens brake dust.
Cold water with special high-dose detergent ad-
dition while mixing in compressed air.
Application before the car wash and only
on coated or painted wheels.
Under-chassis Wash
Removing coarse dirt from the underchassis.
Washing cycle begins with a delay of ap-
prox. 10 seconds; drive the vehicle back-
wards and forwards over the under-chassis
wash.
39