Start Up; Operation; Shutting Down; Storage - Kärcher SHD-R 3000 Originalbetriebsanleitung

Start up

Note: With the device types LM, SLA and
SSR, the plug bushings must be reten-
sioned after the initial start-up. This reten-
sioning procedure should take place one,
two, four and ten hours after the initial start-
up (Run-in phase of seals - See chapter

"Care and Maintenance").

Operation

Working with the hand spray gun
!
There is a recoil pressure arising from the
water jet that comes out from the spray
pipe. The angular spray pipe brings about
an upward force.
DANGER
– Risk of injury! The recoil pressure of the
spray pipe can throw you off-balance.
You may fall. The spray jet can fly off
and cause damage to persons. Search
a secure place to stand and hold the
gun firmly. Never hold on tightly to the
lever of the hand spray gun.
– The jet must not be directed at other
persons or directed by the user at him/
herself to clean clothing or footwear.
– Risk of injury from parts flying off! Fly-
ing-off fragments or objects can injure
people or animals. Never direct the wa-
ter jet on fragile or loose objects.
– Risk of accident on account of damage!
Clean tyres and valves from a minimum
distance of 30 cm.
32
Appliance type
Stationary appliance
The stationary device is intended for instal-
lation on a base. It is mounted onto a sta-
bile steel frame, well-suited for fixed in-
stalled high-pressure lines.
 Open the cleaning liquid supply.
 Switch on the appliance at the main
switch.
 Perform the cleaning operation.
Mobile appliance
The mobile appliance is mounted on a cart
and can be used at different working loca-
tions.
 Place the appliance on a horizontal sur-
face.
 Lock the wheel brakes.
 Open the cleaning liquid supply.
 Switch on the appliance at the main
switch.
 Perform the cleaning operation.

Shutting down

Note: Flush appliance without detergents
prior to shutting it off. This will avoid crust-
ing and adhesion and thus a premature
wear of the seals.
Note: With circuit operation with solvents,
the system must be flushed with clean sol-
vents.
 Switch voltage to the appliance off at
main switch.
 Shut off the cleaning liquid supply.
 If you use a hand spray gun: Pull the le-
ver on the hand spray gun to release
any remaining excess pressure in the
system.
12
-
EN

Storage

CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.

Transport

CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Care and maintenance
The basis for a safe operational plant is
regular maintenance.
Use only original parts of the manufacturer
or part suggessted by him, such as
– replacement and wear parts
– Accessory parts
– Fuel
– Detergent
DANGER
Risk of accident while working on the unit!
During all tasks:
 Remove voltage from and secure high
pressure pump at the main switch.
 Shut off the cleaning liquid supply.
 If you use a hand spray gun: Pull the le-
ver on the hand spray gun to release
any remaining excess pressure in the
system.
Who may perform maintenance?
 Operator
Work designated with the sign "Opera-
tor" may only be carried out by persons
who have been instructed in the safe
operation and maintenance on the high
pressure plant.
 Customer Service
Work designated with the sign "Cus-
tomer Service" may only be done by the
fitters of Kärcher Customer Service.
Maintenance contract
In order to guarantee a reliable operation
og the equipment, we success, you signed
a maintenance agreement. Please refer to
you local Kärcher service department.