Winding A Bobbin - ELNA eXpressive 820 Gebrauchsanleitung

w
e
(A)
(B)
t
r
q
e
w
q
30

Winding a Bobbin

To remove bobbin, slide bobbin cover plate
q
release button to the right and lift away the
w
bobbin cover plate .
e
Lift out the bobbin . (Always use bobbin type
supplied with machine.)
Lift up the spool pin. Place the spool of thread on
the spool pin with the thread coming off the spool
as shown. Attach the spool holder and press it
firmly against the spool of thread.
NOTE: Spool holder needs to be changed
according to the type of thread spool
(A) Large spool
(B) Small spool
Additional Spool Pin
The additional spool pin can be used to wind a
bobbin without unthreading the machine.
PROCEDURE: Insert the spool stand
e
additional spool pin
r t
felt and spool on the pin with the thread
coming off the spool as shown.
NOTE: Hole is located in front and to the right of
the standard spool pin.
w
and the
q
in the hole . Place the