Inhaltsverzeichnis
Werbung
1
3
2
5
4
6
7
Winding a Bobbin
1. Pull out the flywheel to keep the needle from
moving up and down.
2. Place the spool of thread on the spool pin with
the thread coming off the spool as shown. Pull
the thread over around the bobbin winder thread
guide.
3. Pass the thread through the hole in the bobbin
from inside to the outside. Place the bobbin on
the bobbin winder spindle.
4. Push the bobbin winder spindle to the right.
5. Hold the free end of the thread and press the
foot control. Stop the machine when it has made
a few turns and cut the thread tail close to the
hole in the bobbin.
6. Press the foot control again until the bobbin is fully
wound. Return the bobbin winder spindle to the
left and cut the thread.
7. Push the flywheel back into place. (The machine
needle will not go up and down until you push in
the flywheel.)
26
Werbung
Inhaltsverzeichnis
