Inhaltsverzeichnis
Werbung
r
y
y
q
w
e
t
Embroidering with Optional Free Arm Hoop C
The dimension of the leg or sleeve opening must be large
enough to allow the hoop to move freely. Insert the inner
hoop of large hoop B
If the inner hoop cannot be easily inserted, the opening is
too narrow for free arm embroidery.
Maximum distance for design position inside the opening
from the edge is 200mm (7-7/8")
r
Draw centerlines
Remove extension table. See page 10.
Select hoop "C" in Edit Mode.
Select design or letters (dimensions or design/letters
must be 49mm or less).
NOTE: Built-in designs less than 49mm are 2, 4–9,
12–15, 17–20, 22–30, 35, 36, 38, 39, 45, 47, 48, 50–55
and 58.
Hoop fabric, aligning centerlines
t
.
Place fabric around free arm and lock hoop onto carriage.
Roll up fabric edges so they will not be caught at the neck
of the free arm during embroidery sewing.
Insert the blocking plate (stored in the arm of the hoop)
y
next to the hoop opening. The blocking plate prevents
the fabric edge on the free arm from rolling back into the
embroidery area.
Touch the "Jog" keys to position needle directly over
centerline.
Sew design.
CAUTION: Immediately remove hoop from free arm after
sewing is completed. Never attempt to select a new
design, change modes or switch off machine without first
removing the hoop from the arm.
94
w
q
into the opening
e
.
for design placement.
r
with hoop template
.
Werbung
Inhaltsverzeichnis
Fehlerbehebung
