Warranty Terms & Conditions - TERMA MEG Gebrauchsanweisung

Warranty terms & conditions
1. The subject of this warranty is an elec-
tric heating element with control head.
The product name and characteristics
are specified on the packaging.
2. By accepting the device on purchase, the
Client confirms that the product is of full
value. The Client should immediately in-
form the Seller of any discovered faults
— otherwise it will be understood that
the Product was faultless at the time of
purchase. This refers especially to any
faults or damages of the control panel
case.
3. The Warranty for period for the Product
is 24 months from the date of purchase,
but no longer than 36 months from the
date of production.
4. Any claims made will be processed on
production of the warranty card and the
evidence of purchase. The manufacturer
has the right to reject any claim on the
grounds of failure to present any of the
above documents.
5. This warranty does not cover any faults
and/or damages caused by:
— incorrect (not in accordance with
the manual) installation, use or
disassembly,
— incorrect use of the heating ele-
ment (i.e. for any purpose that is not
26
User manual MEG, DRY, MOA, REG 2, REG 3
specified by the Manufacturer as in-
tended for this type of product),
— unqualified persons tampering with
the product,
— customers after the purchase.
6. The Central Heating installation should
be fitted with lock-shield valves, enabling
disassembly of the radiator or the heat-
ing element and its control head without
the necessity of emptying the whole sys-
tem of the heating agent. Any problems
or expenses arising from the absence of
lock-shield valves in your installation can-
not be used as grounds for any claims
against the Supplier or Manufacturer of
the device.
7. The attached Product Manual is an in-
tegral element of the Warranty. Please
read it carefully prior to the installation
and use of the Product.
8. The Manufacturer is obliged to remove
any production fault within 14 working
days of receipt of the faulty device at the
Manufacturer's premises.
9. Should the repair be impossible, then
the manufacturer is obliged to replace
the faulty Product with a new, full-value
unit of identical parameters.