TERMA MEG Gebrauchsanweisung Seite 16

ing time indicator and allow the user to pre-
set the "switch off" time of the device to be-
tween 1 and 5 hours from the current time.
After this time, the heater will turn off
automatically.
It is useful to know that:
• Longer pressing of the button will au-
tomatically set the timer to 5 hours or,
turn off the TIMER function,
• The button can also be used when the
heater is off. On pressing the button, the
heater will automatically turn on and set
the TIMER to 1 hour,
• If you want to turn the TIMER off, press
the button several times or simply turn
the heater off and on,
• TIMER LED diodes will turn off one by
one, to display the correct, remaining
drying time.
The construction of the heater as well as
physical characteristics of various heating
liquids may cause an uneven heat distribu-
tion inside the towel rail. As a result, bottom
pipes of the towel rail may stay cool. Such
phenomenon is completely normal and is
not an indication of heater failure.
16
User manual MEG, DRY, MOA, REG 2, REG 3
Modification of radiator heating
temperature
The default temperature of the heater is
48° C. The user can modify the heating tem-
perature by following these steps:
1. Disconnect the device from the electric-
ity supply (i.e. unplug the device).
2. Press and hold the on/off button while
reconnecting the heater to the electric-
ity supply.
3. Release the button.
4. One of 5 TIMER diodes will start flashing.
Select the required temperature value by
pressing the button until the correspond-
ing diode starts flashing. Temperature
values for each diode are shown in the
table below:
52°
5. Wait for 10 seconds or press the TIMER
button in order to confirm your chosen
value.