TERMA MEG Gebrauchsanweisung Seite 15

DRY
TIMER indication
Indication of heater current
Functions
Heater DRY has 1 fixed temperature set- ting
(default temperature of 48° C) and an ad-
vanced range of automatic switch off func-
tions after 1-5 hours. This makes the prod-
uct convenient and user-friendly — perfect
for drying clothing and towels. The default
heating temperature for the towel rail can
be set to any of the following values: 43, 48,
52, 55 or 60° C. A built-in temperature sen-
sor protects the towel rail from freezing in
situations where the temperature falls be-
low 5-7° C. The LED diode next to the on/off
button will flash recurrently, indicating that
the anti-freeze protection is active.
EN
TIMER button
working state
On / off button
Heater use
The heater is turned on by pressing the on/off
button. The LED diode at the on/off button
lights up when the heater is on and the regu-
lator maintains the set heating temperature.
Attention: the heater control panel turns the
device on only when radiator temperature
is lower than the set temperature (default
temperature of 48° C). On reaching the re-
quired temperature, the heater will turn on
recurrently to maintain the set temperature
only. This function allows much lower ener-
gy consumption than calculations based on
the heaters nominal heat output might in-
dicate. In the upper left part of the control
panel, there is a (TIMER) button which can
be used to set the automatic switch off time
of the device. Every subsequent pressing of
the buttons will light up diodes on the heat-
15